Laser marking and engraving of a logo on wood

Laser marking and engraving of a logo on wood

16/02/2022

Macsa ID equipment is used to code and mark products made from a wide variety of materials, including paper, cardboard, plastics (PET, PVC, HDPE), glass, metals and wood. The messages and graphics that are achieved are high quality, at a minimum operating cost and at high speeds.


Application News demonstrates a sample of products that are coded and marked with Macsa ID lasers, every day and around the world.

Making an elegant and attractive product for the customer is currently essential, and precisely the marking on wood must be aesthetic and detailed. Therefore, we present an Applications News article where the possible reactions and results of the range of lasers with CO2 technology on wood.

Laser marking and engraving of a logo on wood

Reaching this level of finishes is possible thanks to Macsa ID’s CO2 range technologies, but the type of application to be carried out must be considered to decide the power of the laser. Accordingly, the greater the power, the greater the speed. As a result, accurate marking can be achieved. The lens will also be considered, which will directly depend on the marking area.

Our range of SPA 2 lasers is the one that has the greatest capacity to adapt to each project. Thanks to the possibility of choosing not only the lens, but also multiple powers, depends on the marking area. If the area to be marked is small, and the marking does not require very high speeds, we can opt for our range of iCON Series lasers, which are compact and easy to adapt to most production lines due to their small size.

Laser marking and engraving of a logo on wood

An elegant deep finish was sought after in these stoppers. This was successfully achieved thanks to our SPA HPD 30W laser, which achieves an engraving on the material that allows the marked logo to stand out. If, on the other hand, a marking without engraving was required, we would apply less power so that the marking would remain superficial.

Laser marking and engraving of a logo on wood

Technical Data for Laser marking and engraving of a logo on wood

 

If you are looking for the best laser solution for coding and marking on wood, do not hesitate to contact us: